R&S FSV-K8 Operating Manual page 97

®
R&S FSV-K8
Parameters:
<MeasType>
Example:
Mode:
Manual operation:
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
OPOWer
Output Power measurement, see
Measurement", on page 22
ACLR
Adjacent Channel Power measurement, see
"Adjacent Channel Power
MCHar
Modulation Characteristics measurement, see
"Modulation Characteristics
ICFTolerance
Initial Carrier Frequency Tolerance measurement, see
ter 3.1.4, "Initial Carrier Frequency Tolerance
on page 26
CFDRift
Carrier Frequency Drift measurement, see
rier Frequency Drift Measurement", on page 27
RTPower
Relative Transmit Power (EDR) measurement, see
ter 3.1.6, "Relative Transmit Power (EDR)
on page 28
IBSemissions
Spurious Emissions (EDR) measurement, see
"In–band Spurious Emissions (EDR)
DPENcoding
Differential Phase Encoding (EDR) measurement, see
ter 3.1.9, "Differential Phase Encoding (EDR)
on page 32
CFSTability
Carrier Frequency Stability and Modulation Accuracy (EDR)
measurement, see chapter 3.1.8, "Carrier Frequency Stability
and Modulation Accuracy (EDR)
*RST: OPOWer
CONF:BTO:MEAS ACLR
Selects the measurement of the adjacent channel power.
BT
See "Output Power" on page 35
See "TX Spec ACLR" on page 40
See "Modulation Char"
See "Init Carr Freq Tol"
See "Carr Freq Drift" on page 43
See "Rel TX Power" on page 44
See "Spurious Emissions"
See "Carr Freq Stability"
See "Diff Phase" on page 48
chapter 3.1.1, "Output Power
chapter 3.1.2,
Measurement", on page 24
Measurement", on page 25
Measurement",
chapter 3.1.5, "Car-
Measurement",
measurement", on page 29
measurement",
measurement", on page 31
on page 41
on page 43
on page 46
on page 47
chapter 3.1.3,
chap-
chap-
chapter 3.1.7,
chap-
97