Honda INTERCEPTOR 2002 Service Manual page 424

FRONT WHEEL/ SUSPENSION/ STEERING
U.S.A. only:
Place the steeri ng head bearing outer races using
the special tools listed below.
TOOLS:
Main bearing driver attachment 07946-M E90200
Fork seal driver weight 07947-KA50100
Oil seal driver 07965-MA60000
Installer shaft 07VMF-KZ30200
Installer attachment A 07VMF-MAT0100
Installer attachment 8 07VMF-MAT0200
Remover attachment A 07VMF-MAT0300
Remover attachment 8 07VMF-MAT0400
Install the special tools into the steering head pipe
as shown.
Align remover attachment A with the groove in the
steering head.
While holding the installer shaft with the wrench,
turn the upper nut gradually to remove the upper
bearing outer race.
Install the special tools into the steering head pipe
as shown.
Align remover attachment 8 with the groove in the
steering head.
While holding the installer shaft with the wrench,
turn the lower nut gradually to remove the lower
bearing outer race.
UPPER NUT
FORK SEAL
DRIVER WEIGHT
UPPER BEARING
OUTER RACE
REMOVER
ATTACHMENT A
LOWER NUT
INSTALLER
ATTACHMENT B
INSTALLER
ATTACHMENT B
INSTALLER SHAFT
UPPER NUT
REMOVER
ATTACHMENT B
LOWER BEARING
OUTERRACE------~~~
OIL SEAL DRIVER
MAIN BEARING
DRIVER ATTACHMENT
LOWER NUT
13-35