Thermostat - Honda INTERCEPTOR 2002 Service Manual

COOLING SYSTEM
Install the water pump cover drain bolt with a new
sealing washer, and tighten the bolt securely.
Fill the system with the recommended coolant
through the filler opening up to filler neck.
Remove the radiator reserve tank cap and fill the
reserve tank to the upper level line.
Bleed air from the system as follows:
1. Shift the transmission into neutral. Start the
engine and let it idle for 2-3 minutes.
2. Snap the throttle 3- 4 times to bleed air from the
system.
3. Stop the engine and add coolant up to the proper
level if necessary. Reinstall the radiator cap.
4. Check the level of coolant in the reserve tank and
fill to the upper level if it is low.
THERMOSTAT
REMOVAL
6-8
Drain the coolant (page 6-6).
Remove the throttle body (page 5-63).
Disconnect the bypass hose from the water pump
cover.