Honda INTERCEPTOR 2002 Service Manual page 370

The sealmg washer
location is indi-
cated on the upper
crankcase using the
'/::,. • mark.
Further tighten the 9 mm bolts 90 degrees in the
numerical order case on the lower crankcase.
Tighten the lower crankcase 6 mm bolts and 7 mm
bolts in a crisscross pattern in several steps (page
11-14).
TORQUE: 7 mm b olt: 18 N ·m (1.8 kgf·m, 13 lbf·ft)
Recheck that the swingarm pivot collars are seated
in the crankcase.
Install the upper crankcase 10 mm bolts.
Inst all a new sea ling washer and 6 mm bolts.
Tighten the 10 mm bolts to the specified torque.
TORQUE: 39 N ·m (4.0 kgf·m, 29 lbf·ft)
Tighten the 6 mm bolts in a crisscross pattern in 2
or 3 steps.
Install the mainshaft bearing set plate.
Apply a locking agent to the set plate bolt threads.
Install and t ighten the bolts.
CRANKCASE/ TRANSMISSION
~
SEALING WASHER
10 mm BOLTS 6 mm BOLTS 10 mm BOLTS
11-15