Honda INTERCEPTOR 2002 Service Manual page 71

FRAME/ BODY PANELS/ EXHAUST SYSTEM
2-22
Fully install the seat release lock by aligning the rear
fender B and bracket slits.
Secure the seat release lock with the retainer.
Install the seat release cable to the rear fender B
wire guide.
Route the rear sub-harness properly and install it
into the rear fender B wire guide.
Secure the rear sub-harness and seat release cable
with the wire clip.
Install the PGM-FI fuse case to the rear fender B.
Install the starter relay to the rear fender B bosses.
Install the battery (page 17-6).
Route the rear sub-harness and seat release cable
properly, then clamp them to the seat rail wit h the
wire band.