Honda INTERCEPTOR 2002 Service Manual page 307

CYLINDER HEAD/ VALVES
Always replace the
Install the joint collars and new 0-rings into the cyl-
0-rmgs wtth new
inder head.
ones.
Install the camshaft holder A with the "IN" mark fac-
ing to the intake side.
Install the cam-
Install the "I" marked camshaft holder B onto the
shaft holder 8 w1th
intake camshaft and the "E" marked camshaft holder
their bosses facing
B onto the exhaust camshaft.
the holder A
Apply clean engine oil to the threads and seating
surfaces of the camshaft holder flange bolts.
Install new sealing washers and flange bolts.
Tighten the camshaft holder A flange bolts in a
cri sscross pattern in two o r more steps unti l the
holder rests lightly on the cylinder head surface.
Tighten the cam-
Tighten the camshaft holder B flange bolts gradu-
shafr holder bolts.
ally in two or more steps.
startmg With the
bolts at the dowel
pms, m two or more
steps.
7ighten the cam-
Tighten the camshaft holder A bolts to the specified
shaft holder bolts in
torque, then the camshaft holder B bolts.
a cnsscross pattern
m 2 or 3 steps.
TORQUE: 12 N ·m (1.2 kgf·m, 9 lbf.ft)
8-44