Honda INTERCEPTOR 2002 Service Manual page 526

7. Rechecking Indicator Function
Remove the front wheel speed sensor and
replace it with a new one.
Connect the ABS control unit 12P (Black) connec-
tor.
Perform the pre-start self -diag nosis and check
the ABS indicator.
Is the indicator blinking?
YES - Faulty ABS control unit.
NO - Faulty removed wheel speed sensor.
Problem code 3 and 9: Rear wheel speed sensor
system and ABS control unit
1. Wheel Pulser Air Gap Inspection
Check the area around t he rear wheel speed sen-
sor.
Measure the air gap between the speed sensor
and pulser ring.
Standard air gap: 0.4- 1.2 mm (0.02- 0.05 in)
Is there correct air gap?
NO - Check each part fo r deformation and
looseness and correct accordingly.
YES - GO TO STEP 2.
2. Wheel Pulser Magnetic Deposits Inspection
Check for iron or other magnetic deposits
between the pulser ring and speed sensor.
Check for a loose pulser ring or speed sensor.
Check the pulser ring f or deformation or damage
(e.g., chipped teeth) and the speed sensor t ip for
damage.
Are there any deposits between gap?
YES - Remove any deposits and install prop-
erly or replace any faulty part.
NO - GO TO STEP 3.
ANTI-LOCK BRAKE SYSTEM (ABS)
(
16-11