Nuts, Bolts, Fasteners - Honda INTERCEPTOR 2002 Service Manual

Standard type :
Spring pre-load can be adjusted by turning the
adjuster cam.
TURN CLOCKWISE:
Decrease the spring pre-load
TURN COUNTERCLOCKWISE:
Increase the spring pre-load
PRE-LOAD ADJUSTER STANDARD POSITION:
2nd groove
REBOUND DAMPING ADJUSTERS
I
NOTICE
I
• Always start on full hard when adjusting the
damping.
• Do not turn the adjuster screws more than the
given positions or the adjusters may be dam-
aged.
The rebound damping can be adjusted by turning
the adjusters.
DIRECTION H: Increase the damping force
DIRECTION S: Decrease the damping force
Turn the rebound adjuster clockwise until it stops,
then turn the adjuster counterclockwise.
REBOUND ADJUSTER STANDARD POSITION:
1 - 1/4 tums out from full hard
NUTS, BOLTS, FASTENERS
Check that all chassis nuts and bolts are tightened
to th eir correct torque values (page 1-12).
Check that all safety cl ips, hose clamps and cable
stays are in place and properly secured.
MAINTENANCE
PRE-LOAD ADJUSTER
REBOUND ADJUSTER
3-33