Pressure Regulator - Honda INTERCEPTOR 2002 Service Manual

FUEL SYSTEM (Programmed Fuel Injection)
Install the new 0-ring onto the rail joint f lange.
Assemble the fuel rails and rail joi nt.
Install the fue l rai l over t he injectors, being careful
not to damage the 0-rings and cushion rings.
Install and tighten the fuel rail mounting bolts t o the
specified torque.
TORQUE: 10 N ·m (1.0 kgf·m, 7 lbf ·ft)
Rou te the throttle body sub-harness into the throttle
body.
The throttle body
Connect t he injector connectors to each injector.
sub-harness has
Connect the TP sensor connector.
identification marks
Connect t he vacuum hose to t he pressure regulator.
for injector connec-
tions Install the
Install the throttle body (page 5-67).
injeccor conneccors
in the proper loca-
tions.
PRESSURE REGULATOR
REMOVAL
5-70
I
NOTICE
Do not apply excessive force to the fuel rail.
Disconnect the vacuum hose f rom the pressure reg -
ulator.
Hold the fuel rail bracket nut securely, loosen the
pressure regulator lock nut, then remove t he pres-
sure reg ulator.
0 -RINGS
I>
RAIL JOINT
BOLTS