Honda INTERCEPTOR 2002 Service Manual page 179

FUEL SYSTEM (Programmed Fuel Injection)
Disconnect the ECM connectors.
Connect t he test harness to t he wire harness
connectors.
Measure the voltage at the test harness termi-
nals.
Connection: 812 (+ )- 85 (-)
Standard: Battery voltage
Does battery voltage exist?
NO - Open circuit in Black/white wire
between the ECM connector and No.1
02 sensor 4P (Natural) connector.
YES - Replace the ECM with a new one, and
inspect it again.
PGM-FI MIL 24 BLINKS (No.2 02 SENSOR HEATER)
1. N0.2 Oz Sensor Connection Inspection
Turn the ignition switch OFF.
Disconnect the No.2 02 sensor 4P (Black) con-
nectors.
No.2 02 SENSOR 4P (BLACK) CONNECTOR
Check for loose or poor contact on the No.2 02 No.2
o
2
SENSOR 4P (BLACK) CONNECTOR
sensor 4P (B lack) connector.
Connect the No.2 02 sensor 4P (Black) connector.
Place the motorcycle on its side stand.
Check that t he MIL blinks.
Start the engine and check that the MIL blinks.
Is the MIL blinking?
NO - Loose o r poor contact on the No.2 Oz
sensor connector.
YES - GO TO STEP 2.
5-44