Oil Cooler - Honda INTERCEPTOR 2002 Service Manual

LU BRICATION SYSTEM
Apply oil to the clutch outer guide, oil pump drive
sprocket, drive sprocket and drive chain.
Install the clutch outer guide, drive/driven sprocket
and drive chain as an assembly.
Apply a locking agent to the oil pump driven
sprocket bolt threads.
Install and tighten the driven sprocket bolt/washer
to the specified torque.
TORQUE: 18 N·m (1.8 kgf·m , 13 lbf·ft)
Install the oil strainer and oil pan (page 4-7).
Install the clutch assembly (page 9-1 1 ).
Fill the crankcase with recommended engine oil,
and check for oil leaks (page 3-14).
Check the oil pressure (page 4-5).
OIL COOLER
REMOVAL
4-14
Drain the engine oil (page 3-15).
Remove the side cowl and inner half cowl (page 2-
8).
Remove the oil cooler pipe joint SH bolts.
Remove the oil cooler hose bolt and oil cooler hose
joint on each side.