Bearing Holder - Honda INTERCEPTOR 2002 Service Manual

REAR WHEEL/SUSPENSION
Remove the snap ring and brake caliper stay.
Remove the bearing holder from the swingarm.
BEARING HOLDER
BEARING REPLACEMENT
Turn the inner race of each radial bearing with your
finger.
Bearings should turn smoothly and quietly. Also
check that the bearing outer race fits tightly in the
bearing holder.
Check the needle rol ler for obvious signs of wear
Always replace the
Remove and discard the radial ball bearings if the
bearings in pairs.
races do not turn smoothly and q uietly, or if t hey fit
loosely in the bearing holder.
Replace the needle bearing if it is wear or damaged.
Remove the dust seal.
Remove the retaining rings from each side.
14-10
SNAP RING
CALIPER STAY
-·-
COLLAR
RETAINING RING