Honda INTERCEPTOR 2002 Service Manual page 152

FUEL SYSTEM {Programmed Fuel Injection}
Disconnect the ECM connectors.
Connect the test harness to the ECM connectors.
Turn the ignition switch ON.
Measure the voltage at the test harness termi-
nals (page 5-1 0).
Connection: A4 (+)- 816 (-)
Standard: 2.7- 3.1 V
( 1,013 kPa/760 mmHg)
Is the voltage within 2.7- 3.1 V?
No - Faulty MAP sensor.
YES - GO TO STEP 3.
3. MAP Sensor Signal Inspection at Idle
Start the engine.
Measure the voltage at the test harness termi-
nals (page 5-1 0).
Connection:
Standard:
A4 (+)- 816 (-)
2 .7 V minimum
Is the voltage at the standard value?
YES - Faulty MAP sensor.
NO - Replace the ECM with a new one, and
inspect it again.
PGM-FI MIL 7 BLINKS (ECT SENSOR)
1. ECT Sensor Connection Inspection
Turn the ignition switch OFF.
Disconnect the ECT se nsor 3P connector.
ECM
ECT SENSOR 3P CONNECTOR
5-17