Honda INTERCEPTOR 2002 Service Manual page 306

• If camshaft holder replacement is required,
replace the holder and cylinder head as an
assembly.
• Follow this procedure from beginning to end,
even if you are only servicing one cylinder head
camshafts.
• Check the camshaft marks so that you install
each camshaft in its correct location.
• The marks on the camshaft mean the following:
FA: Front cylinder camshaft
RR: Rear cylinder camshaft
IN: Intake camshaft
EX: Exhaust camshaft
• Apply molybdenum oil solution to the cam lobes
and journals.
• Check the camshaft holder marks as noted dur-
ing removal, so that you install each camsha ft
holder in its correct location.
WHEN BOTH THE FRONT AND REAR
CAMSHAFTS WERE REMOVED:
Turn the crankshaft clockwise and align the "3T"
mark on the ignition pulse generator rotor with the
index ma rk on the right crankcase cover.
Make sure that the No.3 piston is at TDC (Top Dead
Center) on the compression stroke.
Apply molybdenum oi l solution to the camshaft
journals of the cylinder head and camshaft holder.
Install the rear cylinder intake and exhaust cam-
shafts with the index lines o n the cam sprocket fac-
ing outward.
CYLINDER HEAD/VALVES
IDENTIFICATION MARK
8-43