Chapter 1 Installing the StackLink
Installing the Top Mounting Tray Assembly
Figure 4 Securing the
Top Mounting Tray
Assembly to the Rack
8
4 Position the top mounting tray assembly in the rack, referring to
figure 4
for the correct orientation.
Position the front and rear flanges of the top mounting
Note:
tray assembly outside of the rack rails.
FRONT
5 Secure the top mounting tray assembly to the rack, using eight screws
(PN YS42011) and washers (PN YS40404) provided in the StackLink
kit (see
figure
4).
If the rack has widely spaced mounting holes, it may not
Note:
be possible to use all four screws to secure the rear flanges.
If this is the case, one screw per side at the rear is
acceptable.
6 Fully tighten the six screws and washers securing the rear support
arms to the sides of the top mounting tray.
ATL StackLink™ Installation Instructions
REAR