Chapter 3 Installing The Libraries Installing Tape Drives In The Libraries; Installing Tape Drives In The Libraries - Quantum ATL StackLink Installation Instructions Manual

Quantum atl stacklink: install guide
Hide thumbs Also See for ATL StackLink:
Table of Contents

Advertisement

Chapter 3 Installing the Libraries

Installing Tape Drives in the Libraries

Installing Tape Drives in the Libraries
50
7 Insert a no. 2 POZIDRIV screwdriver into one of the holes and turn
the rack mount clamp screw clockwise to tighten it fully.
Do not overtighten the rack mount clamp screw.
Caution:
When the screw begins to feel tight, turn it an
additional quarter turn and then stop.
As you tighten this screw, a lever protrudes from the side of the
library and presses against the back side of the rack rail.
8 Tighten the remaining rack mount clamp screw (or screws) in the
same manner.
9 Close the magazine access doors.
10 Repeat steps
3
through
11 After all the libraries are installed, fully tighten the StackLink vertical
shuttle assembly (see
This section explains how to install tape drives in the library. You will
need the following tools for this procedure:
®
TORX
T-20 screwdriver
TORX T-8 screwdriver (if you are installing a drive in drive bays 3
through 6 of an ATL M2500)
Flat blade screwdriver
ATL StackLink™ Installation Instructions
9
to install any additional library modules.
figure
13).
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATL StackLink and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents