Rack Mounting The Autoloader; Understanding Autoloader Features; General Features - Quantum SuperLoader 3 User Manual

Rack Mounting the Autoloader

Understanding Autoloader Features

General Features

Quantum SuperLoader 3 User's Guide
To rackmount the autoloader, you need to select an open 2U computer
rack location near the server that will host the autoloader.
For instruction on mounting the autoloader in a standard 19-inch rack,
see "Rack Mounting the Autoloader"
The autoloader is compatible with most operating systems and
2
environments that support the SCSI, Fibre Channel, or SAS (Serial
Attached SCSI) interface, but requires either direct support from the
operating system or a compatible backup application to take full
advantage of its many features.
Whenever you power cycle the autoloader, allow 10
Caution:
seconds before turning the power back on. The power
supply requires at least two to three seconds for the
capacitors to discharge. This ensures a complete system
reset on power down and may avoid system errors.
Chapter 2 Installation and Configuration
Rack Mounting the Autoloader
on page 93.
15