Connecting An Atl M2500 Library To Ac Power - Quantum ATL StackLink Installation Instructions Manual

Quantum atl stacklink: install guide
Hide thumbs Also See for ATL StackLink:
Table of Contents

Advertisement

# of
Library
200-240V 50-60Hz supply voltage
Modules
(Europe & international, etc.)
10
Same requirements as 6-9 above.
Connecting an
ATL M2500 Library
4
to AC Power
Distribution Unit Requirements
To connect an ATL M2500 library to AC power:
1 Referring to
table
your library configuration and input voltage.
AC distribution units (power strips) must be certified
Warning:
for safety by an agency acceptable to the country of
use. For use in the United States and Canada,
distribution units must be UL listed and CSA certified.
For use in Europe, distribution units must be CE
marked. National certifications for other countries
depend on local requirements.
2 Using one of the short AC power cables provided in the accessory kit,
connect the top power supply to the AC distribution panel on the
back of the library (see
3 Using the remaining short AC power cable, connect the bottom
power supply to the AC distribution panel (see
4 Connect the power cable (provided in the accessories kit) to the
power inlet on the back of the library (see
outlet or AC distribution unit.
ATL StackLink™ Installation Instructions
Chapter 4 Cabling the Multiple Library Stack
100-120V 50-60Hz supply voltage
(USA, Canada, Japan, etc.)
Same requirements as 6-9 above, but
the AC power distribution unit must
also have a ground warning label.
8, select appropriate AC distribution unit(s) for
figure
51).
Power Cabling
figure
51).
figure
51) and to the wall
75

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATL StackLink and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents