Figure 31 Installing The Front Shelf Clamps - Quantum ATL StackLink Installation Instructions Manual

Quantum atl stacklink: install guide
Hide thumbs Also See for ATL StackLink:
Table of Contents

Advertisement

Figure 31 Installing
the Front Shelf
Clamps
6 Install the rear shelf clamps (see
Position a rear shelf clamp (PN 215201/01) on the rear left rack
a
rail, aligning the square hole with the middle insert in the shelf
flange.
Verify that two of the round holes line up with holes in the rack
b
mount shelf. If two of the holes do not line up, rotate the clamp
180 degrees.
Secure the rear shelf clamp to the shelf using two M4 countersink
c
screws (PN YS42064).
Repeat these steps to install a rear shelf clamp on the rear right
d
rack rail.
The left and right rear shelf clamps will be oriented
Note:
differently from one another.
ATL StackLink™ Installation Instructions
Chapter 2 Installing the Rack Mount Shelves
figure
32):
Installing the Shelves
43

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATL StackLink and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents