Chapter 5 Completing The Installation Configuring The Library; Configuring The Library - Quantum ATL StackLink Installation Instructions Manual

Quantum atl stacklink: install guide
Hide thumbs Also See for ATL StackLink:
Table of Contents

Advertisement

Chapter 5 Completing the Installation

Configuring the Library

Configuring the Library
84
5 Press the
button until the
Down
Set the drive SCSI ID to
Caution:
drive installed in the drive bay.
6 Press
.
Select
7 Repeat steps
3
through
this library module.
8 Press
to return to the main screen.
Main
If you do not return to the main screen after changing
Caution:
this setting, your change will not be saved to NVRAM.
You must reboot the library before this setting will take
Note:
effect.
9 Repeat steps
1
through
library modules.
10 Turn all of the libraries in the multiple library stack off and then back
on again.
Library configuration works somewhat differently in a multiple library
than it does in a single library module.
The library must be power cycled before any configuration
Note:
changes will take effect.
ATL StackLink™ Installation Instructions
setting is selected.
Disabled
Disabled
6
to disable any other unused drive bays in
8
to disable any unused drive bays in other
only if there is no
5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATL StackLink and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents