Table of Contents
Advertisement
Installing the Slide
Assembly in the Rack
Removing the Library
from the Pallet
If you are installing a rack-mount library, install the slide assembly in
the rack before proceeding to the next section, "Removing the Library
2
from the Pallet." See appendix B for slide assembly installation
instructions.
This section provides separate procedures for the stand-alone and
rack-mount libraries:
2
To remove a stand-alone library from the pallet, see the following
•
section, "Removing a Stand-alone Library from the Pallet."
To remove a rack-mount library from the pallet, see "Removing a
•
Rack-mount Library from the Pallet" on page 23.
Warning: Two people should perform steps that involve lifting or
guiding the library. Use safe practices when lifting or
guiding the library and handling the slide assembly or the
ramp.
Removing a Stand-alone Library from the Pallet
To remove a stand-alone library from the pallet:
Procedure
Remove the plastic bag enclosing the P1000:
1
Cut along the front seam of the plastic bag.
a
Continue to cut all the way to the back of the library.
b
Fold the bag out of the way.
c
Remove the foam supports from between the library and the pallet
2
(see figure 15).
ATL P1000 Series User's Guide
Chapter 2 Installing the P1000 Library
Unpacking the P1000
2
21
Advertisement
Table of Contents
