Scsi Import/Export Elements; Tape Drive Scsi Ids; Library Scsi Settings - Quantum ATL StackLink Installation Instructions Manual

Quantum atl stacklink: install guide
Hide thumbs Also See for ATL StackLink:
Table of Contents

Advertisement

SCSI Import/
5
Export Elements
Tape Drive SCSI
5
IDs
Library SCSI
5
Settings
To configure SCSI import/export elements using the
option, you must use the GUI on the GUI master. See the ATL M-Series
Library User's Guide (PN 6423002) for more information about this option.
The GUI master is the library module that is connected to the
Note:
StackLink motor (see
Although the
Caution:
all of the library modules, it is only functional on the GUI
master.
To set tape drive SCSI IDs, use the GUI on the library module that
contains the tape drives you wish to affect. For example, the addresses of
tape drives installed in library level 2 should be set from the GUI on
library level 2.
The SCSI host can be connected to any of the library modules. The SCSI
settings for the multiple library stack (SCSI ID, emulation mode, etc.) are
determined by the settings of the library module that is connected to the
host (the SCSI master).
If you change the SCSI settings from the defaults, it is recommended that
you change all library modules to the same settings.
ATL StackLink™ Installation Instructions
Chapter 5 Completing the Installation
figure 48
on page 69).
option appears on the GUIs of
Import/Export
Configuring the Library
Import/Export
85

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATL StackLink and is the answer not in the manual?

Table of Contents