Table of Contents
Advertisement
Chapter 3 Installing the Libraries
Installing Tape Drives in the Libraries
Installing Tape
Drives in an
3
ATL M2500
Figure 37 Drive Bay
Numbering,
ATL M2500
52
To install tape drives in an ATL M2500:
1 At the back of the library, use a TORX T-20 screwdriver to remove the
cover plate protecting the drive bay in which you will install the tape
drive.
The cover plates for drive bays 3 through 6 also have a
Note:
TORX T-8 screw that must be removed to access the drive
bay.
Populate the drive bays in the following order: drive bay
Note:
1, drive bay 2, drive bay 4, drive bay 5, drive bay 6, drive
bay 3 (see
are installed in the library.
Drive bay 2
Drive bay 6
ATL StackLink™ Installation Instructions
figure
37). Drive bay 3 is used only if six drives
Drive bay 1
Drive bay 5
Drive bay 3 (this
drive bay is empty
unless a sixth drive
is installed)
Drive bay 4
Advertisement
Table of Contents
