Reverting To The Factory-Default Configuration Using The Factory Reset/Mode Button On Ex2300, Ex3400, And Ex4300-48Mp Switches - Juniper EX4300 Series Hardware Manual

Reverting to the Factory-Default Configuration Using the Factory Reset/Mode button
on EX2300, EX3400, and EX4300-48MP Switches
To set the EX2300 switches except the EX2300-24MP and EX2300-48MP switches, EX2300-C
switches, EX3400 switches, and EX4300-48MP switches to the factory-default configuration, use the
Factory Reset/Mode button located on the far right side of the front panel.
NOTE: To revert a member switch of a Virtual Chassis to the factory-default configuration,
disconnect the cables connected to the VCPs to avoid affecting Virtual Chassis configuration
parameters (member ID, primary-role priority, and setting of VCP uplinks) on other members (see
Disconnect a Fiber-Optic Cable
To revert to the factory-default configuration by using the Factory Reset/Mode button:
1. Press the Factory Reset/Mode button for 10 seconds. The switch transitions into factory-default
configuration, the console displays committing factory default configuration, and the Link/Activity
LED on the RJ-45 network ports and the uplink ports is lit steadily in green color.
2. Press the Factory Reset/Mode button for 10 more seconds. The switch transitions into initial setup
mode, the console displays committing ezsetup config, and the Link/Activity LED on the RJ-45
network ports and the uplink ports blink in green color.
The Factory Reset/Mode button is enabled by default. You can disable the button using the CLI.
To disable the Factory Reset/Mode button, run the commands:
1. [edit]
user@switch# set chassis config-button no-clear
2. [edit]
user@switch# commit
To enable the Factory Reset/Mode button, run the commands:
1. [edit]
user@switch# delete chassis config-button no-clear
2. [edit]
user@switch# commit
RELATED DOCUMENTATION
Connecting and Configuring an EX Series Switch (CLI Procedure)
Connecting and Configuring an EX Series Switch (J-Web Procedure)
).
255