Maintaining An Uplink Module In An Ex4300 Switch - Juniper EX4300 Series Hardware Manual

Hide thumbs Also See for EX4300 Series:

Table of Contents

5. Using both hands, place the power supply in the power supply slot on the rear panel of the switch

and slide it in until it is fully seated and the ejector lever fits into place.

Figure 91: Installing a DC Power Supply in an EX4300 Switch

NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade of

hardware components at

Failure to do so can result in significant delays if you need replacement parts. This note does not

apply if you replace existing components with the same type of component.

Maintaining an Uplink Module in an EX4300 Switch

IN THIS SECTION

Removing an Uplink Module from an EX4300 Switch | 304

Installing an Uplink Module in an EX4300 Switch | 306

https:/ /www.juniper.net/customers/support/tools/updateinstallbase/