Juniper EX4300 Series Hardware Manual page 393

ports pour intérieur de l'appareil sont réservés au raccordement de câbles pour intérieur
ou non exposés uniquement. L'ajout de protections ne constitue pas une précaution
suffisante pour raccorder physiquement ces interfaces au câblage de l'installation
extérieure.
CAUTION: Before removing or installing components of a device, connect an
electrostatic discharge (ESD) grounding strap to an ESD point and wrap and fasten the
other end of the strap around your bare wrist. Failure to use an ESD grounding strap
could result in damage to the device.
Attention Avant de retirer ou d'installer des composants d'un appareil, raccordez un
bracelet antistatique à un point de décharge électrostatique et fixez le bracelet à votre
poignet nu. L'absence de port d'un bracelet antistatique pourrait provoquer des dégâts
sur l'appareil.
• Install the device in compliance with the following local, national, and international electrical codes:
• United States—National Fire Protection Association (NFPA 70), United States National Electrical
Code.
• Other countries—International Electromechanical Commission (IEC) 60364, Part 1 through Part 7.
• Evaluated to the TN power system.
• Canada—Canadian Electrical Code, Part 1, CSA C22.1.
• Suitable for installation in Information Technology Rooms in accordance with Article 645 of the
National Electrical Code and NFPA 75.
Peut être installé dans des salles de matériel de traitement de l'information conformément à
l'article 645 du National Electrical Code et à la NFPA 75.
• Locate the emergency power-off switch for the room in which you are working so that if an electrical
accident occurs, you can quickly turn off the power.
• Make sure that you clean grounding surface and give them a bright finish before making grounding
connections.
• Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
• Never assume that power is disconnected from a circuit. Always check the circuit before starting to
work.
• Carefully look for possible hazards in your work area, such as moist floors, ungrounded power
extension cords, and missing safety grounds.
383