Lcd Panel In Ex4300 Switches - Juniper EX4300 Series Hardware Manual

LCD Panel in EX4300 Switches

IN THIS SECTION
LCD Panel Modes | 55
LCD Panel Menus | 56
The LCD panel on the front panel of the EX4300 switch shows two lines of text, each with a maximum
of 16 characters. The LCD panel displays a variety of information about the switch and also provides a
menu to perform basic operations such as initial setup and reboot.
There are two navigation buttons—Menu and Enter—to the right of the LCD panel.
See Figure 16 on page 54.
Figure 16: LCD Panel in EX4300 Switches
1 LCD panel
—
2 LCD panel Enter button
—
The first line of text on the LCD panel displays basic information about the switch and the second line of
text displays information about the mode selected on the LCD panel. You can configure the second line
of the text for the LCD panel to display a custom message. If the LCD panel is configured to display a
custom message, the Menu button and the Enter button are disabled. See
EX Series Switches (CLI Procedure)
The LCD panel has a backlight. If the LCD panel is idle for 60 seconds, the backlight turns off. You can
turn on the backlight by pressing the Menu or Enter button once. After turning on the backlight, you can
toggle between the LCD panel menus by pressing the Menu button and navigate through the menu
options by pressing the Enter button.
3 LCD panel Menu button
—
4 Chassis status LEDs
—
.
Configuring the LCD Panel on
54