Reverting To The Factory-Default Configuration Using The Ex Series Switch Lcd Panel - Juniper EX4300 Series Hardware Manual

2. [edit] user@switch# delete system commit factory-settings
3. [edit] user@switch# set system root-authentication plain-text-password
4. [edit] user@switch# commit
5. Check the member ID and primary-role priority with the
see whether there are remaining settings for uplink VCPs by using the
command.

Reverting to the Factory-Default Configuration Using the EX Series Switch LCD Panel

To set the switch to the factory-default configuration, for EX Series switches, you can use the LCD panel
and buttons on the front panel of the switch. If the EX Series switch model does not have an LCD panel,
use one of the procedures described in the following sections.
Figure 85: EX Series Switch LCD Panel
NOTE: To revert a member switch of a Virtual Chassis to the factory-default configuration, first
disconnect the cables connected to the Virtual Chassis ports (VCPs) to avoid affecting Virtual
Chassis configuration parameters (member ID, primary-role priority, and setting of VCP uplinks)
on other members. See
from an EX4200 Switch
To revert to the factory-default configuration by using the LCD panel:
1. Press the Menu button until you see MAINTENANCE MENU on the panel.
2. Press the Enter button.
3. Press Menu until you see FACTORY DEFAULT.
4. Press Enter. The display says RESTORE DEFAULT?
5. Press Enter. The screen flashes FACTORY DEFAULT IN PROGRESS and returns to the idle menu.
6. Complete the initial configuration of the switch. See
(CLI Procedure) Connecting and Configuring an EX Series Switch (J-Web Procedure)
or
Disconnect a Fiber-Optic Cable
, or Disconnecting a Virtual Chassis Cable from an EX4500
command and check to
show virtual-chassis
show virtual-chassis vc-port
Disconnecting a Virtual Chassis Cable
,
Connecting and Configuring an EX Series Switch
254
Switch.
.