Juniper EX4300 Series Hardware Manual page 192

1. Attach the wall-mount brackets to the sides of the chassis by using four of the wall-mount bracket
screws on each side (see the representation in
tighten the screws.
Figure 61: Attaching Wall-Mount Brackets to the Switch Chassis
2. If you are mounting two switches together, line the second switch on top of the first and attach it to
the mounting brackets by using two wall-mount bracket screws on each side (see the representation
in Figure 62 on page
3. Insert the mounting screws in the wall. If you are mounting EX4300 switches except EX4300-48MP
and EX4300-48MP-S switches, insert the top pair of mounting screws 474.35 mm apart, and insert
the second pair of mounting screws 151.81 mm directly below the first set. If you are mounting
EX4300-48MP and EX4300-48MP-S switches, insert the top pair of mounting screws 474.2 mm
apart, and insert the second pair of mounting screws 152 mm directly below the first set (see
63 on page 184 and Figure 64 on page
If the mounting screws are inserted in a wall board with no stud behind it, you must use dry wall
anchors rated to support 75 lb (34 kg). Insert the screws into wall studs wherever possible to provide
added support for the chassis.
Drive the screws only part way in, leaving about 1/4 in. (6 mm) distance between the head of the
screw and the wall. Use the screwdriver to drive the screws in.
183).
185).
Figure 61 on page 182). Use the screwdriver to
182
Figure