Connect An Ex Series Switch To A Management Console Using The Mini-Usb Type-B Console Port - Juniper EX4300 Series Hardware Manual

port to connect the device to the console server or management console. The console port accepts a
cable that has an RJ-45 connector.
To connect the device to a management console (see
207):
1. Connect one end of the Ethernet cable to the console port (labeled CON, CONSOLE, or CON1) on
the device.
2. Connect the other end of the Ethernet cable to the console server (see
management console (see
Figure 73: Connect a Device to a Management Console Through a Console Server
Figure 74: Connect a Device Directly to a Management Console
Connect an EX Series Switch to a Management Console Using the Mini-
USB Type-B Console Port
Before You Begin
Before you connect the switch using the Mini-USB Type-B console port:
• Ensure that the USB to Serial driver is installed on the host machine.
• Ensure that the HyperTerminal properties of the console server or laptop are set as follows:
• Baud rate—9600
Figure 73 on page 207
Figure 74 on page 207).
and Figure 74 on page
Figure 73 on page 207) or
207