Juniper EX4300 Series Hardware Manual page 68

Table 11: LCD Panel Menu Options in EX4300 Switches
Menu Label Description
MAINT The Maintenance menu has the following options to configure and troubleshoot the
(Maintenance switch:
Menu)
•
•
•
•
•
•
SYSTEM HALT?—Choose one of the following:
•
Press Enter to halt the switch. Press Enter again to confirm the halt.
•
Press Menu to go to the next option in the Maintenance menu.
SYSTEM REBOOT?—Choose one of the following:
•
Press Enter to reboot the switch. Press Enter again to confirm the reboot.
•
Press Menu to go to the next option in the Maintenance menu.
LOAD RESCUE?—Choose one of the following:
•
Press Enter to roll back the switch to the previous valid configuration. Press Enter
again to confirm the rollback.
•
Press Menu to go to the next option in the Maintenance menu.
REQUEST VC PORT?—Choose one of the following:
•
Press the Enter button to configure an uplink module port or a built-in QSFP+ port
to be a VCP or to delete a VCP from the switch configuration (when you delete the
VCP, the port is reset to be an uplink module port or a network port).
•
Press the Menu button to go to the next option in the Maintenance menu.
FACTORY DEFAULT?—Choose one of the following:
•
Press Enter to restore the switch to the factory default configuration. Press Enter
again to confirm the restoration. The LCD panel flashes a success or failure
message, after which it displays the Idle menu.
•
Press Menu to go to the next option in the Maintenance menu.
ENTER EZSETUP?—Choose one of the following:
•
Press Enter to launch EZSetup. Press Enter again to confirm the launch.
(Continued)
58