Juniper EX4300 Series Hardware Manual page 256

• EX3200, EX3300, EX4200, EX4300 switches except EX4300-48MP and EX4300-48MP-S
switches, EX4500, EX4550, EX6200, or EX8200 switch—Use the Menu and Enter buttons
located to the right of the LCD panel (see
Figure 83: LCD Panel in an EX3200, EX4200, EX4500, EX4550, or EX8200 Switch
Figure 84: LCD Panel in an EX4300 Switches Except EX4300-48MP and EX4300-48MP-S
Switches
LCD panel
1
—
LCD panel Enter button
2
—
a. Press the Menu button until you see MAINTENANCE MENU. Then press the Enter button.
b. Press Menu until you see ENTER EZSetup. Then press Enter.
If EZSetup does not appear as an option in the menu, select Factory Default to return the
switch to the factory default configuration. EZSetup is displayed in the menu of standalone
switches only when a switch is set to the factory default configuration.
c. Press Enter to confirm setup and continue with EZSetup.
2. Connect the Ethernet cable from the Ethernet port on the PC to the switch.
• EX2200, EX3200, or EX4200 switch—Connect the cable to port 0 (ge-0/0/0) on the front panel
of the switch.
• EX3300 switch—Connect the cable to the port labeled MGMT on the rear panel of the switch.
Figure 83 on page 246 or
LCD panel Menu button
3
—
Chassis status LEDs
4
—
Figure 84 on page 246):
246