Juniper EX4300 Series Hardware Manual page 254

Configure out-of-band management —Configure the management port. In out-of-band
•
management, you use a dedicated management channel (MGMT port) to connect to the
management device. Specify the IP address and gateway of the management interface. Use this
IP address to connect to the switch.
7. Specify the SNMP read community, location, and contact to configure SNMP parameters. These
parameters are optional.
8. Specify the system date and time. Select the time zone from the list. These options are optional.
9. The configured parameters are displayed. Enter yes to commit the configuration. The configuration
is committed as the active configuration for the switch.
10. (For EX4500 switches only) Enter the operational mode command request chassis pic-mode
intraconnect to set the PIC mode to intraconnect.
You can now log in with the CLI or the J-Web interface to continue configuring the switch. If you use the
J-Web interface to continue configuring the switch, the Web session is redirected to the new
management IP address. If the connection cannot be made, the J-Web interface displays instructions for
starting a J-Web session.
SEE ALSO
Connecting and Configuring an EX Series Switch (J-Web Procedure)
Installing and Connecting an EX2200 Switch
Installing and Connecting an EX2300 Switch
Installing and Connecting an EX3200 Switch
Installing and Connecting an EX3300 Switch
Installing and Connecting an EX3400 Switch
Installing and Connecting an EX4200 Switch
Installing and Connecting an EX4300 Switch | 170
Installing and Connecting an EX4550 Switch
Installing and Connecting an EX4500 Switch
Installing and Connecting an EX6210 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
244