Juniper EX4300 Series Hardware Manual page 253

• See Switch Fabric and Routing Engine (SRE) Module in an EX8208
• See Routing Engine (RE) Module in an EX8216
NOTE: In EX2200-C, EX2300, EX3400, EX4300, and EX4550 switches, you can also use the
Mini-USB Type-B console port to connect to a laptop or PC. See
Switch to a Management Console Using the Mini-USB Type-B Console Port
At the Junos OS shell prompt root%, type ezsetup.
2.
3. Enter the hostname. This is optional.
4. Enter the root password you want to use for the device. Reenter the root password when
prompted.
5. Enable services such as SSH and Telnet.
NOTE: You will not be able to log in to the switch as the root user through Telnet. Root login
is allowed only through SSH.
• The default option for SSH is yes. Select this to enable SSH.
• The default option for Telnet is no. Change this to yes to enable Telnet.
6. Use the Management Options page to select the management scenario:
NOTE: On EX2300 and EX3400 switches, you cannot create a new VLAN for management.
On EX4500, EX6200, and EX8200 switches, only the out-of-band management option is
available.
Configure in-band management . In in-band management, you configure a network interface or
•
an uplink module (expansion module) interface as the management interface and connect it to
the management device.
In this scenario, you have the following two options:
• Use the automatically created VLAN
all data interfaces as members of the default VLAN. Specify the management IP address and
the default gateway.
• Create a new VLAN for management—Select this option to create a management VLAN.
Specify the VLAN name, VLAN ID, management IP address, and default gateway. Select the
ports that must be part of this VLAN.
Switch.
default for management—Select this option to configure
Switch.
Connect an EX Series
.
243