Table 25: Status LED on 100/1000/2500/5000/10000BASE-T Ethernet Network Ports on
EX4300-48MP and EX4300-48MP-S Switches
LED
Status Mode LED
DX
SPD
POE
Starting in Junos OS Release 20.1R1, you can use the
switches to identify the switch or a port on the switch. When you execute the command, the status
LEDs on the RJ-45 network ports blink two times per second irrespective of the mode the ports are
operating in (see
How to Locate a Device or Port Using the Chassis
Table 26 on page 82
describes the Status LED on the ports on the 4-port 1-Gigabit Ethernet SFP/10-
Gigabit Ethernet SFP+ uplink module for EX4300-48MP and EX4300-48MP-S switches.
(Continued)
State and Description
Indicates the duplex mode. The status indicators are:
•
Green—Port is set to full-duplex mode.
•
Unlit—Port is set to half-duplex mode.
NOTE: In EX4300 switches, the ports operate in full-duplex mode only.
Indicates the speed. The speed indicators are:
•
Unlit—10 Mbps
•
Blinking green—100 Mbps
•
Steadily green—1000 Mbps
•
Blinking amber—5000 Mbps
•
Steadily blue—10000 Mbps
Indicates the PoE mode. The status indicators are:
•
Steadily green—PoE is enabled on the port and a device is drawing
power.
•
Blinking green—PoE is enabled on the port, but no power is drawn
from the port.
•
Unlit—PoE is not enabled on the port.
request chassis beacon
command on EX4300-48MP
Beacon).
81