Juniper EX4300 Series Hardware Manual page 334

Table 90: Chassis Component Alarm Conditions on EX4300 Switches
Chassis Component Alarm Condition
Management Management
Ethernet interface Ethernet link is
down
Routing Engine /var partition usage
is high.
/var partition is full.
Rescue configuration
is not set.
Feature usage
requires a license or
the license for the
feature usage has
expired.
SEE ALSO
Field-Replaceable Units in EX4300 Switches | 52
Chassis Status LEDs on EX4300 Switches | 69
Understand Alarm Types and Severity Levels on EX Series Switches | 320
Alarm Severity Remedy
Major (red)
•
Check whether a cable is connected to the
management Ethernet interface, or whether
the cable is defective. Replace the cable if
required.
•
If you are unable to resolve the problem,
open a support case using the Case
Manager link at
support/
within the United States and Canada) or
1-408-745-9500 (from outside the United
States).
Minor (yellow Clean up the system file storage space on the
or amber) switch. For more information, see
System Storage
Major (red) Clean up the system file storage space on the
switch. For more information, see
System Storage
Minor (yellow
Use the
or amber)
save
command to set the rescue configuration.
Minor (yellow Install the required license for the feature
or amber) specified in the alarm. For more information,
see Understanding Software Licenses for EX
Series Switches.
(Continued)
https:/ /www.juniper.net/
or call 1-888-314-5822 (toll-free
Freeing Up
Space.
Freeing Up
Space.
request system configuration rescue
324