Juniper EX4300 Series Hardware Manual page 285

Table 80: Chassis Viewer for EX4100 and EX4100-F Switches
Field
USB port
Chassis status LEDs
Port mode LEDs
Factory Reset/Mode button
Virtual Chassis ports
Rear View
Management port
Console port
USB port
(Continued)
Description
Displays USB Type C console port.
Displays status LEDs labeled SYS, ALM, MST, and CLD.
Displays port mode LEDs labeled SPD, DX, EN, and
PoE.
Displays the Factory Reset/Mode button, which is used
to reset the switches to the factory-default
configuration.
EX4100 and EX4100-F switches have dedicated
Virtual Chassis ports (VCPs) that you can use to
interconnect member switches of a Virtual Chassis.
You can interconnect a maximum of 10 switches to
form a Virtual Chassis.
The management port (MGMT) is used to connect the
switch to a management device for out-of-band
management.
The Console port (RJ-45) labeled as CON is used to
connect the switch to a management console or to a
console server.
Indicates the USB port for the switch.
NOTE: We recommend that you use USB flash drives
purchased from Juniper Networks for your EX Series
switch.
275