Reverting To The Default Factory Configuration For The Ex Series Switch - Juniper EX4300 Series Hardware Manual

NOTE: The buttons on the LCD panel are disabled when the LCD is configured to display a
custom message.
To disable the display of the custom message:
user@switch> clear
chassis display message
You can view the custom message by issuing the

Reverting to the Default Factory Configuration for the EX Series Switch

IN THIS SECTION
Reverting to the EX Series Switch Factory-Default Configuration Using the request system zeroize
Command | 252
Reverting to the EX Series Switch Factory-Default Configuration Using the load factory-default
Command | 253
Reverting to the Factory-Default Configuration Using the EX Series Switch LCD Panel | 254
Reverting to the Factory-Default Configuration Using the Factory Reset/Mode button on EX2300,
EX3400, and EX4300-48MP Switches | 255
With EX Series switches, if for any reason the current active configuration fails, you can revert to the
factory-default configuration.
You can also roll back to a previous configuration, as described in
Changes, or revert to the rescue configuration, as described in
the EX Series Switch.
TIP: If you have lost the root password, it is not necessary to revert to the factory-default
configuration to reset it. See
show chassis lcd
Recovering the Root Password on
command.
Rolling Back Junos OS Configuration
Reverting to the Rescue Configuration for
Switches.
251