Uplink Modules In Ex4300 Switches - Juniper EX4300 Series Hardware Manual

Table 11: LCD Panel Menu Options in EX4300 Switches
Menu Label Description
•
You can disable the Maintenance menu or the options in the Maintenance menu in the
LCD panel. See
SEE ALSO
EX4300 Switches Hardware Overview | 2
Connecting and Configuring an EX Series Switch (CLI Procedure)

Uplink Modules in EX4300 Switches

EX4300 switches provide a slot to install an optional uplink module. Uplink modules are hot-insertable
and hot-removable field-replaceable units (FRUs).
You can install an uplink module horizontally in the uplink module slot on the front panel of the switch.
By installing an uplink module, you add more ports to your switch, thereby increasing the port density of
the switch.
Table 12 on page 60 shows the uplink modules supported on 24-port and 48-port EX4300 switches
except EX4300-48MP and EX4300-48MP-S switches, their descriptions, and the Junos OS release in
which the models were released.
EZSetup configures DHCP and enables the J-Web user interface on the switch. The
LCD panel flashes a success or failure message for approximately 10 seconds, after
which it displays the Idle menu.
NOTE: You can use EZSetup only on a standalone switch that is in the factory
default configuration.
For information about EZSetup, see
Switch (J-Web Procedure)
•
Press Menu to go to the next option in the Maintenance menu.
EXIT MAINT MENU?—Choose one of the following:
•
Press Enter to exit the Maintenance menu.
•
Press Menu to return to the SYSTEM HALT? option.
Configuring the LCD Panel on EX Series Switches (CLI Procedure)
Table 13 on page 60
(Continued)
Connecting and Configuring an EX Series
.
shows the uplink modules supported on 32-port
59
.