Table of Contents
Advertisement
n Enable/Disable Teleservice [En./Dis.Teleser.]
Select this option to enable/disable the Panel for incoming Teleservice calls.
A beep and the following message will confirm request Done:
Teleservice
Teleservice
Disabled
Disabled
Use
Press
When the Panel (duly enabled for Teleservice) connects to the Installer PC (via telephone line), the installer will be
able to:
Ø View the Panel status: ----Partition status; Alarm memory; Zone bypass; Zone status; Event buffer; Peripheral de-
vice status.
Ø Change the Panel status: ----Partition status; Delete the alarm memory; Bypass zones (User code PIN required).
Ø Change the Panel parameters: ----all partitions must be disarmed.
The Teleservice facility allows the Installer to work on the system via PC, and deal with trouble events that do not
require new wiring or components.
An Q above the
n Enable/Disable Answering machine [En./Dis.Answer.]
This option is provided by the OmniaVOX board (optional).
Select this option from the USER MENU to enable/disable the Answering machine----incoming calls will be an-
swered by a Voice message.
A beep and the following message will confirm request Done:
Answering mach.
Answering mach.
Disabled
Disabled
Press
Press
An Q above the
available (refer to TELEPHONE OPTIONS).
n Output management
Select this option to allow manual control of one or more outputs. Manual control via keypad will allow the User to
turn duly wired household appliances ON and OFF (e.g. garden sprinklers, outdoor lighting, etc.).
The output list will be shown first, followed by the list of devices.
Garden lights
Garden lights
ON-Act.OFF-Stdby
ON-Act.OFF-Stdby
Use
Press
+
Only outputs programmed as Reserved for manual control can be used for this purpose.
A similar option is available via telephone (refer to TELEPHONE OPTIONS).
n Code programming
This option is available to Master codes only. The Code hierarchy (Masters and Slaves) must be programmed by
the Installer. Master codes can select/deselect the Active status of their Slave codes, and change their PINs.
Active User codes An Active User code can control its enabled partitions and options only.
If the Active status is deselected the User code will be unable to control the system.
+
The Active status of a Master User code cannot be deselected, therefore, this type of request will be signalled by
an error beep.
PIN A 4 to 6 digit Personal Identification Number (programmed by a Master code User) will identify each User code,
and its enabled options.
Programming User codes:
Step 1 Enter the Master code then select Code programm. option.
A list of the relevant Slave codes will be shown, as below:
KEYPAD OPTIONS
or
to Enable/Disable Teleservice.
to exit.
icon means Teleservice is enabled.
or
to Enable/Disable the answering machine.
to exit.
icon means the Answer machine option is enabled, therefore, all the telephone options are
or
to scroll the list.
or
to Activate/Deactivate the selected output.
11
Advertisement
Table of Contents
