Figure 9-24 4 Mm Tape Auto-Loader: Removing The Mounting Brackets; Figure 9-25 Disconnecting The Scsi Data Cable - Sun Microsystems SPARCcenter 2000 Service Manual

9
Left bracket
9-20
4. Use the 5 mm hex-head socket to remove the screws that attach the two
mounting brackets to the auto-loader. See Figure 9-20.
Save the screws for the new drive.
Fan power cable
Front view

Figure 9-24 4 mm Tape Auto-Loader: Removing the Mounting Brackets

Figure 9-25 Disconnecting the SCSI Data Cable

Note – If you are not replacing the auto-loader with another drive, install a
full-high or two half-high cover plates over the empty drive bay. Then, replace
the panels and power on the system using the instructions given in Part 3—
"Preparing for Service."
SPARCcenter 2000/2000E Service Manual—June 1996
Fan subassembly bracket