Power Supply Cover; Figure 7-5 Removing The Power Supply Cover - Sun Microsystems SPARCcenter 2000 Service Manual

7.6 Power Supply Cover

To remove the power supply cover:
1. Loosen the six #6 Phillips screws that secure the cover to the frame.
Removing the screws is not necessary since the cover has slotted screw
holes. Figure 7-5 shows the screws removed for ease of identification.
2. Lift the panel up until the slotted screw holes clear the screw heads.
3. Lift out the panel and set it aside.
#6 Phillips screws
Figure 7-5 Removing the Power Supply Cover
To replace the power supply cover, reverse the above instructions.
Internal Access
7
Power supply cover
7-7