Kick Panel; Stabilizer Bar; Figure 7-7 Removing The Kick Panel - Sun Microsystems SPARCcenter 2000 Service Manual

7.8 Kick Panel

7.9 Stabilizer Bar

!
1. Loosen the two captive screws. See Figure 7-7.
To replace the kick panel:
1. Arrange cables (if applicable) neatly behind the kick panel, then fasten
the two captive screws to secure the panel in place.
Figure 7-7 Removing the Kick Panel
Warning – Always extend the stabilizer bar before pulling the disk drive trays
out for servicing.
The cabinet has six levelling pads. Four pads on the cabinet frame are lowered
to touch the floor and prevent the cabinet from rocking. Two levelling pads are
part of the stabilizer bar and should not touch the floor.
1. Extend the stabilizer bar fully from the bottom of the cabinet.
See Figure 7-8.
2. Screw the two stabilizer bar levelling pads down until they are
-inch (3 to 6 mm) above the floor.
1
/
4
Ensure both pads are at equal heights. This clearance allows the stabilizer
bar to slide in and out easily, yet catch the cabinet if it should begin to tilt.
Internal Access
Kick panel
Captive screws
7
- to
1
/
8
7-9