Sun Microsystems SPARCcenter 2000 Service Manual page 320

Index-6
differential SCSI tray, 9-36
set, 9-36
cable
data, 12-17
connector
location, 9-9, 9-16, 9-24, 9-28, 9-33
bus parity, 9-29
disk tray
assembly, 12-14
remove/replace, 8-47
drive
numbering, E-11
probe, 3-15
ID connector
location, 9-5, 9-28, 9-29, 9-32
probe test, 3-15
tray
cabling, E-12
service, 9-1
select
locations
SIMM, E-7
SuperSPARC modules, E-4
system boards, E-1
sense, power cable, 8-6
serial port
A for TTY terminal, 3-8
connector pinout, D-3
set link integrity test, 11-9
setup, terminal, 3-8
shut down, system, 6-1
side panels See panel, remove
SIMM
installation, E-8
locations, E-7
memory fault, 4-6
options, E-7
remove and replace, 11-11 to 11-15
U-number, 11-11
slave system boards, E-4
software, operating system, 4-11
specification, A-1
altitude, A-5
electrical, A-2
SPARCcenter 2000/2000E Service Manual—June 1996
environment, A-4
humidity, A-4
physical, A-1
stabilizer bar
adjust, 7-9
safety, 7-9
standard features, 1-1
standoff
lock and unlock, 11-4
using, 11-3
start
POST, 3-9
status LEDs, location, 2-4
SuperSPARC module
connectors, E-5
location, 10-2, E-4
pinout, D-13
remove and replace, 11-4 to 11-6
slots, 3-19
troubleshoot, 4-4
sweep cycle enabled connector, 9-29
switch
key, 12-7
local/remote, 6-5
reset, initiate POST, 6-7
symbols, definitions, 5-2
system
compliance information, xxvi
control, sequence, 2-1
functional description, B-1
precautions, 5-3
system board
approved ESD mat, 10-1
description, 10-2
injector/ejector lever, 8-31
installation, 8-31
jumper, C-4
LEDs, interpret, 3-17
master, 10-3, E-2
overview, 10-1
remove, 11-1
replacement part numbers, 10-3
safe handling, 10-1
slave, E-4