Power Supply Breaker Box - Sun Microsystems SPARCcenter 2000 Service Manual

7.5 Power Supply Breaker Box

Screws (2 places)
Screws (2 places, hidden)
5. Remove the power breaker box from the power supply. See Figure 7-28.
a. Remove two screws from the bottom lip of the box.
b. Loosen two screws at the top of the box.
Figure 7-28 Removing the Power Breaker Box
6. Unplug the power sense cable from the top connector on the power
supply.
7. Remove the sense cable from the breaker box (pass it through holes in the
sheet metal).
8. Remove the box.
To replace the box, use the removal procedure above in reverse.
Major Subassemblies
7
7-29