Cable Removal From The Internal Scsi Tray - Sun Microsystems SPARCcenter 2000 Service Manual

7

7.9 Cable Removal from the Internal SCSI Tray

7-38
2. Insert the two screws through the top mounting holes of the control board
enclosure into the threaded holes in the backplane, and tighten.
This is accomplished from the front of the system.
3. Insert the four screws through the backplane into the lower four threaded
mounting holes of the control board enclosure, and tighten.
This is accomplished from inside the card cage enclosure.
The backplane is now fully installed.
Perform these tasks in order to replace the SCSI tray cables.
Safety and Tools Requirements
Powering Off the System
Opening the Hinged Door
Vented Front Panels
EMI Shield
Drive Assembly Removal (as required—see the note below)
Note – To remove the SCSI data cable and SCSI DC cable from the internal
SCSI tray, all the drive assemblies have to be removed. To remove a SCSI
address cable assembly, it is only necessary to remove the one affected drive.
Figure 7-35 shows the three types of cable used for the SCSI tray.
SPARCcenter 2000/2000E Service Manual—June 1996
page 5-1
page 6-1
page 7-2
page 7-3
page 7-1
page 9-1