Setting Scsi Target Id For The Half Height Tape Drive - Sun Microsystems SPARCcenter 2000 Service Manual

Hide thumbs Also See for SPARCcenter 2000:
Table of Contents

Advertisement

E
E.4 Setting SCSI Target ID for the Half Height Tape Drive
E-6
3. Use the device select switch to set the SCSI address for the installed drive.
Press the buttons marked "+" or "-" until you reach the proper address.
1. Plug the address cable for the half height 8 mm tape drive into the SCSI
ID connector at the rear of the tape drive. See Figure E-1.
Orient the address cable so that the pin 1 of the address cable connector
plugs into pin 1 on the SCSI ID connector at the rear of the drive.
Note – The pin 1 orientation on the 8 mm drive is opposite that of the SunCD
and the 1/4-inch tape drive.
Power connector
SCSI data
connector
Figure E-7
Connector Location: Half Height 8 mm Tape Drive
2. Determine what the SCSI address will be for the half height 8 mm tape
drive you are installing.
The SCSI address for the tape drive can vary depending on the SPARCcenter
2000 system configuration and/or the location of the drive. Table E-1 shows
examples of SCSI addresses for the four drive bays. Figure E-6 shows
possible locations for the half height 8 mm tape drive.
If the tape drive replaces one previously installed in the drive bay, keep the
same SCSI address assigned to the drive that was replaced.
SPARCcenter 2000/2000E Service Manual—June 1996
SCSI ID
1
3
5
connector
2
4
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sparccenter 2000e

Table of Contents