Figure 9-30; Figure 9-31 Inserting The Auto-Loader Into The Drive Bay - Sun Microsystems SPARCcenter 2000 Service Manual

Address cable
Figure 9-30 Positioning the Address Cable
10. Insert and tighten the four screws in the mounting brackets to secure the
autoloader to the cabinet. See Figure 9-31.
Use the 7mm hex-head socket.
se
Clo
en
Op
ive
Dr
e
ss ett
Ca
Sto p
Pr ote ct
Wr ite
DC
se
en Clo
Op
Dr ive
ss ett e
Ca p
Sto
ct
Pr ote
ite
Wr
DC

Figure 9-31 Inserting the Auto-Loader into the Drive Bay

11. Determine the SCSI address for the installed auto-loader.
The SCSI address depends on the location of the auto-loader in the
SPARCcenter 2000 system. Refer to Appendix F for location and SCSI
addressing information.
•
If the auto-loader replaces a drive previously installed in the drive bay, keep
the same SCSI address assigned to the drive that was replaced.
Storage Devices
SCSI ID connector
Black wire
Drive
Fan subassembly
bracket
Screws
9
9-25