Sun Microsystems SPARCcenter 2000 Service Manual page 187

9.6.2 Removing and Replacing the Fan
The fan attached to the fan subassembly bracket is a field replaceable unit
(FRU) part. To order a replacement, contact your Sun representative and
request FRU part number F540-2606-xx.
To remove and replace the fan, first detach the fan subassembly bracket from
the auto-loader. See Section 9.6.1, "Removing the Auto-Loader and
Disconnecting Cables."
1. Remove the two M4 screws holding the fan and finger guard in place.
Save the screws for use when you install the replacement fan.
2. Position the FRU fan so that the cable extends from the top left side.
The fan is positioned properly when the two airflow arrows on the top right
side point to the right and to the rear, away from the auto-loader (the label
on the fan will also face the rear).
3. Attach the fan and finger guard to the bracket using the two screws
removed in step 1.
4. Align the fan subassembly bracket along the right side of the auto-loader.
The fan is at the rear of the device when the bracket is properly aligned.
5. Attach the bracket to the device using the two M3 screws set aside earlier.
6. Connect the fan power cable to the auto-loader.
a. Plug one end of the fan power cable (J1) into the auto-loader power
connector.
The power connector is at the rear. See Figure 9-26.
Storage Devices
9
9-21