Figure 9-21 Drive Bays For 4 Mm Tape Auto-Loaders; Figure 9-22 Removing A 4 Mm Tape Auto-Loader - Sun Microsystems SPARCcenter 2000 Service Manual

9
9.6.1 Removing the Auto-Loader and Disconnecting Cables
9-18
4 mm tape auto-loaders

Figure 9-21 Drive Bays for 4 mm Tape Auto-Loaders

To remove a 4 mm tape auto-loader from a SCSI tray:
1. Use the 7 mm hex-head socket to remove the four mounting screws that
secure the drive to the cabinet. See Figure 9-22.
Mounting screws (4plcs)

Figure 9-22 Removing a 4 mm Tape Auto-Loader

2. Slide the drive out until the cables attached to the drive are exposed.
3. Unplug the power cable, SCSI ID cable, and SCSI data cable from the
connectors at the rear of the auto-loader. See Figure 9-23.
SPARCcenter 2000/2000E Service Manual—June 1996
Cassette Drive
DC Write Protect
Cassette Drive
DC Write Protect
Cassette
0
Compress
Open Close Cassette Drive Open Close
Stop DC Write Protect Stop
Open Close
Stop
Warning Open/Close
Write Protect Step